Aeon door / window sensor

  • 270 Views
  • Last Post 02 March 2016
bucket23 posted this 01 March 2016

I have half a dozen gen1 aeon door / window sensors. They get added and configured o.k. but the status doesn't change on the console.
I have one gen2 aeon door / windows sensor. It seems to work fine.
Anyone know what parameter I need to change.

Thanks.

Order By: Standard | Newest | Votes
rscott posted this 01 March 2016

I have half a dozen gen1 aeon door / window sensors. They get added and configured o.k. but the status doesn't change on the console.
I have one gen2 aeon door / windows sensor. It seems to work fine.
Anyone know what parameter I need to change.

Thanks.


You should only need to make sure it's associated in group 1 with your usb stick. The easy way to do this is to include them using InControl's "include device (network wide)" feature.

Outside of using InControl to include the device, you could use the "association" button to set it, though you'll need to go around and wake each one up before going into associations.

Hope this helps

Ryan

bucket23 posted this 01 March 2016

Thank you for the reply. How do I do the include device network wide?
I have included it the normal way through the aeon stick (gen5).

Thanks.

rscott posted this 01 March 2016

Thank you for the reply. How do I do the include device network wide?
I have included it the normal way through the aeon stick (gen5).

Thanks.


You should see the option from InControl if you go to tools/zwave commands.

bucket23 posted this 02 March 2016

I just fixed it up. I had a vera3 lite running at the same time. Once I turned that off it started to work fine. Not sure why this made a difference though but it did.

Close