Second button control a scene

  • 105 Views
  • Last Post 09 May 2015
Qubino posted this 17 April 2015

I want the second button on my wall switch to control a scene in Incontrol, Is that possible?

I have a qubino flush dimmer and the I2 output is controlling a z-wave device (a lamp) but instead I want it to just send the status changes to Incontrol (not to the lamp) and for example change a scene. But it seems impossible to associate the Qubino with a scene in incontrol?



Is that a multi-channel device? If it is, you'll see some end points listed that you can create a virtual device from. If status changes for that virtual device shop up, you can use that to trigger a scene.

Order By: Standard | Newest | Votes
Ryan-Scott posted this 17 April 2015

I want the second button on my wall switch to control a scene in Incontrol, Is that possible?

I have a qubino flush dimmer and the I2 output is controlling a z-wave device (a lamp) but instead I want it to just send the status changes to Incontrol (not to the lamp) and for example change a scene. But it seems impossible to associate the Qubino with a scene in incontrol?



Is that a multi-channel device? If it is, you'll see some end points listed that you can create a virtual device from. If status changes for that virtual device shop up, you can use that to trigger a scene.

Qubino posted this 08 May 2015

Yes, it is a multi-channel device:

http://qubino.com/products-2/flushdimmer/

I can see two Endpoints, but nothing happens to the endpoints when i push the buttons. When I use wall button nr to Level Changes and the local lamp Changes but Nothing happens to Endpoint 1 or 2.

Any clue?

Ryan-Scott posted this 09 May 2015

Yes, it is a multi-channel device:

http://qubino.com/products-2/flushdimmer/

I can see two Endpoints, but nothing happens to the endpoints when i push the buttons. When I use wall button nr to Level Changes and the local lamp Changes but Nothing happens to Endpoint 1 or 2.

Any clue?



Is InControl setup to poll the device? There may be a way to setup an association to the endpoints or use the config button to configure them to report back to InControl when they change. You could possibly find this in your manual.

Close