I just bought a big batch of fibaro roller shutters 2. Is there some way to copy the parameters from a defined device to all the new ones so i don't have to go through a full parameter list for each device?
Thank you
Claudiu
Device Copy
- 132 Views
- Last Post 14 January 2015
Claudiu
posted this
13 January 2015
Ryan-Scott
posted this
13 January 2015
I just bought a big batch of fibaro roller shutters 2. Is there some way to copy the parameters from a defined device to all the new ones so i don't have to go through a full parameter list for each device?
Thank you
Claudiu
No, but I might could help make your life easier if you can give me the manufacture & product Id from the auto-configure along with the parameters you set and a description of what each does. I can add this to a new build of InControl and all you'll need to do is auto-configure each one.
Claudiu
posted this
13 January 2015
That would be great
Manufacturer ID is 271
Product ID is 4097
Model: Fibaro Roller Shutter 2
Parameters Description Setting
3 Reports type 0
10 Operating Mode 1
12 Time of full turn of lamellas 150
13 Set lamellas back to previuos position 1
14 Switch type 0
17 Reaching a limit switch 10
18 Motor operation detection 10
22 Motor operation time 240
29 Forced Calibration 0
30 Response to general alarm 0
31 Response to flooding alarm 0
32 Response to smoke CO2 alarm 0
33 Response to temperature alarm 0
35 Managing lamellas in response to alarm 1
40 Power reports 10
42 Periodic power or energy reports 3600
43 Energy reports 10
44 Self measurement 0
50 Scenes and association settings 0
Is this ok?
Regards,
Claudiu
Ryan-Scott
posted this
14 January 2015
That would be great
Manufacturer ID is 271
Product ID is 4097
Model: Fibaro Roller Shutter 2
Parameters Description Setting
3 Reports type 0
10 Operating Mode 1
12 Time of full turn of lamellas 150
13 Set lamellas back to previuos position 1
14 Switch type 0
17 Reaching a limit switch 10
18 Motor operation detection 10
22 Motor operation time 240
29 Forced Calibration 0
30 Response to general alarm 0
31 Response to flooding alarm 0
32 Response to smoke CO2 alarm 0
33 Response to temperature alarm 0
35 Managing lamellas in response to alarm 1
40 Power reports 10
42 Periodic power or energy reports 3600
43 Energy reports 10
44 Self measurement 0
50 Scenes and association settings 0
Is this ok?
Regards,
Claudiu
Yes, exactly what I needed. I wonder though... are any of these values "defaults"-- for example, is 31-33 already set to 0 from the factory? If so, we should skip them so that the auto-configure can get through everything before timing out.
