I've watched your youtube videos several times and am still having issues with setting up rules with conditions.
First, my door sensors are reading fine now (thanks to Ryan!) but I can't seem to get them to trigger an email alert if they've been open for longer than 10 minutes. For instance, I've setup a new rule with the following:
Trigger - On Device change state/level
Script - Emailcurrentdevicestate.ics
Enabled
Days of the week - Everyday checked
NodeIDs - Small Garage Door
Off to On - True
On to Off - False
Any Level change False
Conditions - After "Small Garage Door" (name of sensor A) has been = 100 for 10 minutes
My log says "Script aborted because conditions were not met."
If I remove the "for 10 minutes" part, it works like a champ. What am I doing wrong?
Thanks
Rules and Conditions...
- 33 Views
- Last Post 11 December 2012
joe.ak2@gmail.com
posted this
11 December 2012
Ryan-Scott
posted this
11 December 2012
Instead of a trigger of device state change, switch to use a repeating date. Set it up to repeat every minute. It'll check every minute if the sensor has been active for more than 10 minutes and send you the notice.
