Static Offset Values for Devices

  • 50 Views
  • Last Post 23 March 2014
blackhole217@gmail.com posted this 23 March 2014

I have an Aeotec MultiSensor that I recently attached to my system. The motion sensor, luminance, and relative humidity are pretty accurate, but the temperature reading is consistently 6 degrees (F) lower than the actual temperature.

I've confirmed that the device itself doesn't have any programmable offset, so I was hoping the InControl HA software would have this ability, but couldn't find a way to accomplish this.

What I am looking for is a way to specify an offset value (6 degrees in this case) to a specific reading on a device.

Thanks,
~Dan

Ryan-Scott posted this 23 March 2014

I have an Aeotec MultiSensor that I recently attached to my system. The motion sensor, luminance, and relative humidity are pretty accurate, but the temperature reading is consistently 6 degrees (F) lower than the actual temperature.

I've confirmed that the device itself doesn't have any programmable offset, so I was hoping the InControl HA software would have this ability, but couldn't find a way to accomplish this.

What I am looking for is a way to specify an offset value (6 degrees in this case) to a specific reading on a device.

Thanks,
~Dan


There's not a way currently to do this, but please add it as a feature request to our list.

Close