I just fixed it up. I had a vera3 lite running at the same time. Once I turned that off it started to work fine. Not sure why this made a difference though but it did.
Aus AEON smart switch 6
- 282 Views
- Last Post 02 March 2016
rscott
posted this
01 March 2016
these devices keep showing that they are on in the control panel but they are not.
Does anyone know what setting I need to do to get them to show the right status in the control panel.
I'm on the latest beta of the incontrol software.
Thanks.
Here's some info about how to configure that device.
bucket23
posted this
01 March 2016
these devices keep showing that they are on in the control panel but they are not.
Does anyone know what setting I need to do to get them to show the right status in the control panel.
I'm on the latest beta of the incontrol software.
Thanks.
Here's some info about how to configure that device.
Thankyou for the reply, but that link doesn't mention anything about the issue. I might not have been looking properly, could you post the bit around the on off status part.
Thanks.
bucket23
posted this
02 March 2016
I just fixed it up. I had a vera3 lite running at the same time. Once I turned that off it started to work fine. Not sure why this made a difference though but it did.
