Ryan says:
[b]All devices have it right now; we'll address it in a future update that will remove it from non-battery powered devices.
As for your current battery powered devices, they'll show 100% if that device hasn't report it's battery level. One thing you can do to potentially remedy this is to wake the device up and perform a successful auto-configure on it. Additionally, turn on "polling" but make sure you have it set to queue commands until wakeup.
Hope this helps -
Ryan[/b]
After autoconfigure, mine do the same thing: Briefly shows an actual percentage and then quickly jumps to 100% and sits there.
The tribulations and trials of early adopters.
J.
Battery variable on every device?!
- 106 Views
- Last Post 27 June 2015
DarkStar
posted this
23 June 2015
Axial-User
posted this
25 June 2015
Right, what's up with this. All my dimmer's have a "Battery" indicator since version 4.
Also, my door/window sensors (Monoprice, Linear) don't show correct battery status. Always 100% when in fact they are not. I tested recently (re-Auto Configured) and they showed 85% briefly then reverted back to 100%. Perhaps it's not easy to read these mostly sleeping devices correctly?
DarkStar
posted this
27 June 2015
Ryan says:
[b]All devices have it right now; we'll address it in a future update that will remove it from non-battery powered devices.
As for your current battery powered devices, they'll show 100% if that device hasn't report it's battery level. One thing you can do to potentially remedy this is to wake the device up and perform a successful auto-configure on it. Additionally, turn on "polling" but make sure you have it set to queue commands until wakeup.
Hope this helps -
Ryan[/b]
After autoconfigure, mine do the same thing: Briefly shows an actual percentage and then quickly jumps to 100% and sits there.
The tribulations and trials of early adopters.
J.
