Glad to help.
Control of Yale YRD220-ZW
- 130 Views
- Last Post 23 December 2013
vinnmann11
posted this
20 December 2013
rscott
posted this
21 December 2013
Following the instructions on the InControl site, I get to the point where the InControl software says to push the Z-wave button on the device. The network module with the Yale deadbolt has no such button. I am using the Aeonlabs Z-stick series 2. Has anyone been able to get a Yale lock to work with InControl Software?
Help Please!!!
In case you haven't yet, please update to the latest version of InControl -- version 3.62.
Here are some instructions, though they are likely the same as the ones you are following.
As far as the Yale lock is concerned, the manual they provide should have the information you need for how to include/pair it into the network. If they don't have a simple button, they'll have some sort of instructions -- such as entering a code on the door lock, etc. Simply replace those instructions with the "push button" instruction on our website's instruction list and you should be set.
SickPup404
posted this
21 December 2013
Instructions for including/excluding: (Be sure to exclude it first, before including)
EXCLUDE/REMOVE:
1. Put your controller in exclude/remove mode
2. Enter the master PIN code (4-8 digits) then # key
3. Press 7 then # key
4. Press 3 then # key to exclude/remove the door lock
INCLUDE/ADD:
1. Put your controller in include/add mode
2. Enter the master PIN code (4-8 digits) then # key
3. Press 7 then # key
4. Press 1 then # key to include/add the door lock
vinnmann11
posted this
22 December 2013
Thanks SickPup404! That is exactly what I needed to know.
Now, if anyone knows how to set the various parameters with the lock, that would be helpful.
SickPup404
posted this
23 December 2013
Glad to help.
