I have some Jasco GE switches that have an annoying blue LED on when the switch is off. The documentation the came with the switches says you change it so the light come on when the switch is on. Any ideas how to change the parameters ?
When shipped from the factory, the LED on the 45605 is
set to turn ON when the connected outlet is turned OFF.
To make the LED turn ON when the light is turned ON,
change parameter 3’s value to “1”.
- Parameter No: 3
- Length: 1 Byte
- Valid Values = 0 or 1 (default 0)
How to change parameters on a Z wave deceive?
- 51 Views
- Last Post 18 April 2013
Axial-User
posted this
04 December 2012
Ryan-Scott
posted this
04 December 2012
Here's a little video about how to configure your parameters.
Axial-User
posted this
04 December 2012
None of my devices have a parameters button. Is that only avavilable in a certain version of InControl?
Ryan-Scott
posted this
04 December 2012
Yes, it requires Standard edition.
Axial-User
posted this
18 April 2013
I have the Pro version installed on Windows 7 - and I don't see the "Param" button showing up on my screen.
Ryan-Scott
posted this
18 April 2013
I have the Pro version installed on Windows 7 - and I don't see the "Param" button showing up on my screen.
Go to Tools/Options and make sure you have selected the "Beta Z-Wave Controller." This will enable the params button along with many other features.
Axial-User
posted this
18 April 2013
Brilliant! Very many thanks
