Hi
I'm trying to get two ZXT-120 AC IT Extenders working and having trouble with them. I have successfully added them to the network, and at first ( a few weeks ago) they seemed to be working, but after being away for a few weeks I am now working on them again and having problems getting any activity to work.
Here's some details on what does/doesn't work:
- added to network OK (have also removed and re-addedd)
- does not always show all values -sometimes just battery and no temperature values
- no commands get sent to heatpump - I am using a code that worked when first connected
- auto-configure fails
- can get/set parameter values
I'm using IncontrolHA version 4.0.5582.26031
I have also moved InControlHA to a new computer for other reasons, and this problem was the same before and after the move.
Any help will be greatly appreciated.
ZXT-120 not working
- 191 Views
- Last Post 30 April 2015
I also had a problem of ghost device with a 4in1 multisensor...
I tried everything
- Heal node
- Zeentools remove dead nodes
- Exclude / include
But in the end I had to reset the USB stick!
I do not know if you can do it, but if you do you can also update the firmware:
http://aeotec.com/z-wave-usb-stick/1273-z-stick-2e-firmware.html
I've been through most of that before and to be sure, have just run through the list as you've provided.
I have found that there is another Thermostat device I can't delete (reappears if I delete from InCOntrol) which may be from when I was initially testing with batteries and perhaps had not removed the device from the controller before changing to USB power.
Having finished the remove/add process and setting the properties as suggested, I am still getting a Fail on the auto-config. - The message is:
Auto-Configuration Node 19
Associating device with main controller...
...Fail!
Manufacturer Id is 21076. Product Id is 33655.
You said before that the device worked the first time, or am I wrong?
Try this:
- exclude from incontrolha
- remove usb
- exclude from usb
- reset device
- include with incontrolha
- set "Queue Command Untile Wakeup"
- set "Force Poll" 30sec
- set "Audit Node" (for testing than can be removed)
- Offline\Online
- try autoconfig
I'm using it on USB power and following the device instructions, have changed the listening mode from FLIRS to Always Listening
Hi, I don't have this device but when I can't autoconfig I set in properties the flag on "Queue Command Untile Wakeup".
Are you using it with battery or power cable?